If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have installed BJ"s soa kit on 1987 GW the drive line is real close to the cross member. do I have to install limiter for axle drop when I leave the ground?
Mike, on some of the SOA conversions, notching the front x-member is required. Also, a limit-strap is a good idea to keep from breaking parts and eventually snapping / bending springs.
Comment