If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Recently got and installed the bjs offroad 4in lift kit for my 78 Cherokee. After install one side of the vehicle sits visually lower than the other. Any suggestions?
I believe we have been emailing back and forth about this. It could be worn body mounts, but I would first go through the installation procedures listed on our instructions, in the installation instructions section of this forum (essentially, loosen everything up, bounce up and down on all four corners, then tighten, and then go flex all four corners on a ditch / loading ramp / etc).
Comment