Cherokee LED Taillight Installation

[Brent]

On our new Cherokee LED taillight kits, there is a slight modification that needs to be made to your stock housing. These pictures show this mod:

First, you need to pry out the stock plug and bulb socket, this is very easy, you just need to pry it out with a flat-head screwdriver:





This is what the housing will look like without the socket:



This is how the wires are run for the led and shows it before tightening everything up. The led is set on a rubber grommet that tightens down with an included stud and nut:



Here is a link to the Cherokee LED tailight conversion kits:

http://www.bjsoffroad.com/cartgenie/...?pid=806&cid=2

Thanks!

[Ryan]

On the wiring, there will be four wires on the LED's, and they connect as follows: Green - Ground
Black - Tail light
Red - Stop/turn (connect this wire for RapidFire)
Yellow - Stop/turn (connect this wire for no RapidFire)

Rapid Fire is when the LED gives three rapid flashes followed by bright, constant on (this helps to get people's attention behind you). You will use either the Red or the Yellow, but not both. Whichever wire you don't use will need to be taped off with the end covered / protected.