Announcement Announcement Module
No announcement yet.
Offset Dana 44 Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Offset Dana 44

    I swapped out my hydramatic t case with a centered Dana 300 will this be too much angle on the driveshaft with a 6" lift and off center pumpkin?

  • #2
    No, it will still work. Just make sure that you get GOOD quality ujoints, and I'd recommend having the shaft balanced. With stock tcase and our 6" lift, you can use stock driveshafts. But with the D300, I would measure from the D300 output yoke to the rear axle yoke and make sure the shaft is long enough. If not, most local dshaft shops will lengthen and balance for around $100-150.


    • #3
      What kind of a vehicle?


      • #4
        78 wagoneer i replaced the tranny as well with a t18 so driveshaft will def need to be lengthened. I'm either doing the soa on 37s or 6" on 35s and some trimming