Announcement Announcement Module
Collapse
No announcement yet.
Offset Dana 44 Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • gregs7667
    started a topic Offset Dana 44

    Offset Dana 44

    I swapped out my hydramatic t case with a centered Dana 300 will this be too much angle on the driveshaft with a 6" lift and off center pumpkin?

  • gregs7667
    replied
    78 wagoneer i replaced the tranny as well with a t18 so driveshaft will def need to be lengthened. I'm either doing the soa on 37s or 6" on 35s and some trimming

    Leave a comment:


  • Brent
    replied
    What kind of a vehicle?

    Leave a comment:


  • Ryan
    replied
    No, it will still work. Just make sure that you get GOOD quality ujoints, and I'd recommend having the shaft balanced. With stock tcase and our 6" lift, you can use stock driveshafts. But with the D300, I would measure from the D300 output yoke to the rear axle yoke and make sure the shaft is long enough. If not, most local dshaft shops will lengthen and balance for around $100-150.

    Leave a comment:

Working...
X